10Gtek® 10Gb PCI-E NIC Network Card, Dual Copper RJ45 Port, with Intel X540 Controller, PCI Express Ethernet LAN Adapter Support Windows Server/Windows/Linux/ESX, Compare to Intel X540-T2

£9.9
FREE Shipping

10Gtek® 10Gb PCI-E NIC Network Card, Dual Copper RJ45 Port, with Intel X540 Controller, PCI Express Ethernet LAN Adapter Support Windows Server/Windows/Linux/ESX, Compare to Intel X540-T2

10Gtek® 10Gb PCI-E NIC Network Card, Dual Copper RJ45 Port, with Intel X540 Controller, PCI Express Ethernet LAN Adapter Support Windows Server/Windows/Linux/ESX, Compare to Intel X540-T2

RRP: £99
Price: £9.9
£9.9 FREE Shipping

In stock

We accept the following payment methods

Description

TP-Link 10Gbps PCIe Network Card (TX401) - PCIe to 10 Gigabit Ethernet Network Adapter, Supports Windows 10/8.

m CAT6A Ethernet Cable is included—rated for up to 10 Gbps while a regular cable is only rated for 1 Gbps.The motivators were availability, long term cost (impacted both by the switch and the connected gear), thermal signature, and audio signature (more power draw means more cooling).

This operates over four backplane lanes and uses the same physical layer coding (defined in IEEE 802. The autonegotiation protocol selects between 1000BASE-KX, 10GBASE-KX4, 10GBASE-KR or 40GBASE-KR4 operation. SFP+ modules do only optical to electrical conversion, no clock and data recovery, putting a higher burden on the host's channel equalization. Compatible with x8 and x16 standard and low-profile PCI Express slots enables each slot port to operate without interfering or competing with other ports.Cukup telusuri berbagai pilihan 10gb nic terbaik dan filter berdasarkan kecocokan terbaik atau harga untuk menemukan produk yang sesuai untuk Anda! Improved support for virtualization, including VMDq and SR-IOV, makes the NIC a perfect fit for virtualized environments. CX4 applications are now commonly achieved using SFP+ Direct Attach and as of 2011 [update], shipments of 10GBASE-CX4 have been very low. It is designed to provide broad interoperability, critical performance optimisations, and increased agility for communications, cloud, and enterprise IT network solutions. there just aren’t any adapters for that, because consumer market is a bit crap when it comes to practical add in cards that aren’t graphics cards, and datacenters care more about higher bandwidth cards, or cards with more ports, rather than filling 1x slots that don’t exist in server boards.

The I/O virtualisation advances network connectivity by providing FPP, multiple Rx/Tx queues, and on-controller QoS functionality that can be used in both virtual and non-virtual server deployments. and is coming out with new AQC chipsets; They have been rebranded to “mGig” and serve the prosumer part of Marvell’s networking product stack, but their chipset names all still start with AQ. SFP+ modules share a common physical form factor with legacy SFP modules, allowing higher port density than XFP and the re-use of existing designs for 24 or 48 ports in a 19-inch rack width blade. This may not matter as much if you're only trying to get 10Gb between your TrueNAS and the switch, and then 1Gb from the switch to the rest of your machines (as implied by the "house is wired for it" comment) as there are a lot of switches on the market that have only two 10Gb ports with the rest at 1Gb. Many of the posts I found on the subject were a few years old so wanted to check if better info was out there.PCI Express bandwidth is measured in giga transfers, which do not directly translate, due to overhead. Leveraging Broadcom’s market-proven architecture and software, the HP 530SFP+ delivers full line-rate performance across all ports with low power consumption.

In SMF light follows a single path through the fiber while in MMF it takes multiple paths resulting in differential mode delay (DMD). DFB lasers are more expensive than VCSELs but their high power and longer wavelength allow efficient coupling into the small core of single-mode fiber over greater distances.Like 10GBASE-CX4, DA is low-power, low-cost and low-latency with the added advantages of using less bulky cables and of having the small SFP+ form factor. Due to additional line coding overhead, 10GBASE-T has a slightly higher latency (2 to 4 microseconds) in comparison to most other 10GBASE variants (1 microsecond or less). The Open-FCoE architecture uses a combination of FCoE initiators in Microsoft Windows and Linux operating systems and in the VMware ESXi hypervisor to deliver high-performance FCoE solutions using standard 10 GbE Ethernet adapters. Your 1x slot will need to be open ended though to accept a 4x card into it even though only 1 lane will get used.



  • Fruugo ID: 258392218-563234582
  • EAN: 764486781913
  • Sold by: Fruugo

Delivery & Returns

Fruugo

Address: UK
All products: Visit Fruugo Shop