Joint It Simple Jointing Mortar Dark Grey (1 x 20kg) - Large Size

Product Information

We strongly recommend Limestone and Flamed/Honed Black Granite are pre-sealed prior to application of Joint-It Simple. Flamed, honed or Egyptian stone must be sealed on both sides of the paving slab prior to applying Joint-It Simple. It is very important that you ensure the base beneath your paving is permeable prior to applying a permeable product like Joint-It Simple.

It is specially formulated with seven unique specialist types of glue to ensure that it will stay in your joints for many years.Ready to use from the tub, no mixing, no second part to stir in, just open and use, simply brush in. We strongly recommend that you watch our application video before you start the foundations for your paving. Soak Again - when all of the joints are full of the jointing mortar, soak the paving again with water. before you tip out the product, otherwise Joint-It Simple may accentuate any natural discoloration in your paving slabs. If the temperature is above 30°, we recommend that you wait until it is cooler in the evening or early morning before applying Joint-It Simple because water will evaporate too quickly to allow you to brush the product into the joints.

Apply the required amount of Joint-It Slurry Primer to the base and the underside of the slab and reapply the paving slab in place. If you are unsure if your base is permeable, run a hose for several minutes on the top of the paving. Preparation: Make sure all joints are cleaned out to a minimum depth of 25mm (minimum joint width of 3mm) and clear of any dirt.Our range of sponge machines protects the joints between paving slabs by avoiding washing away the cement, whilst the machine removes the need for individuals to wash away grout on their hands and knees. Final Cleaning: Clean the surface carefully with a fine hair broom so that all JOINT-IT residue is removed. Our natural sands harden on contact with air, so simply wet the area, brush in the product, and leave it to do the rest. If you notice small dots on your paving slabs, this indicates that part of the slab was of a harder density, and the residue should weather-off over a 3-6 month period. As long as the joints are a minimum of 3mm wide and 20mm deep, and that the base is water permeable.