Silverline Concrete Rubbing Brick 24 Grit (918552)

Product Information

If tapping doesn't work, casting threads around a suitable greased bolt (if I can get one) might be an option, though might end up plugging the hole permanently. JB Weld test pieces used previously (and therefore high temp cured) were compared with Bondite epoxy, The joints are then brush cleaned to remove excess dust and depending on conditions careful washing out with a hose may be appropriate; however, this would preferably be done at least the day before the application of mortar. Bag rubbing is a simple technique where mortar is applied over masonry in such a way that its neither pointing or rendering, yet offers a sacrificial and protective coating to a wall, without having to extinguish its underlying character. Preparation

Can't believe there isn't a local machine shop that couldn't fit a helicoil for you, it really is the proper way to do it tbh....... You haven't yet told us what you intend to do about the scored cylinder liner yet, think that could be a bigger problem to solve, have you found oversize pistons and rings and a full gasket set?Knowledge of various types and classes of building limes, different types of aggregates, natural pozzolana and artificial pozzolans, natural pigments from ochres and vegetable sources Architects like Stephen prefer curved arches to flat ones but many self-builders choose the latter for reasons of economy. They are also considered just as traditional as curved arches in some parts of the country. If you are building a flat window head with a soldier course, however, you should again be wary. There will be heritage building professionals carrying out this work but numbers and levels of skills are unclear. Small business issues: Firms cannot access sufficient financial support to fund the training of apprentices and up-skilling mature artisans. Before getting started, remember that the appropriate PPE measures should always be used when working with lime. While the joints to the masonry need to be appropriately prepared it doesn’t necessarily demand the same thoroughness as that for pointing. Nonetheless the works should be conducted in a diligent manner with the joints cleaned out to a depth not less than 10 mm but ideally 10-15mm for improved key.

Superior heat resistance of JB Weld over Bondite is thus uncomfirmed ATPIT, (would require higher temperatures) but Bondite is a “fast” epoxy (4 mins) so gives insufficient working time and is probably weaker. This seems to be the norm for readily available epoxies. Personally I think it's a none starter, it may well resist the heat, it'll be protected by the plug after all, think the trouble you'll have is trying to cut a new thread, there simply won't be enough surface area for it to bond too and resist the cutting action of the tap. The mortar should be made using sand appropriate to the masonry being worked on. A 50/50 sand such as CLS30 (50/50 coarse and fine sand – supplied by Cornish Lime) is the most popular for this type of work; while CLS35 (a fine clean washed plastering sand) has been used to good effect on numerous projects, where a coarse sand wasn’t appropriate to the masonry. View our range of coarse and fine sands.

I used ring-pull tabs from Budweiser beer cans (“the King of Beers” yeh, right) as standard test pieces, which seemed somehow appropriate for testing

Aftermarket heads are allegedly 100US. Normally this would be unbelievable, but there was a Charade clone big in China, so maybe just possible. Unfortunately the engine number is on the head, probably precluding a swap in Taiwan.

It is important to select a lime that will yield a mortar strength weaker than the host masonry and our suggested mix would be at 2:5 lime to sand. It wasnt using a lot of oil or noticably down on compression before this unfortunate series of events, so unless the damage is very recent, which I have no particular reason to believe, it wasnt apparently having much functional impact. Re the scored cylinder {which I dont think is quite accurate. "pitted" would be closer) I'm probably not going to do anything. Re-positioning Craft Education and Training to Re-connect Artisans to Designers, The Journal of The Association of Preservation Technology, USA, (2012)